Directions for Cleaning Raised Floors with High Pressure Laminate
Vacuum raised floor thoroughly. Spot clean using full to heavy duty strength solution. Apply with trigger sprayer, let stand 1 to 2 minutes and wipe clean.
- Heavy Duty Strength - For heavily soiled areas. 10 to 12 ounces per gallon of water.
- Medium Strength - For moderately soiled areas. 4 to 8 ounces per gallon of water.
- Regular Strength - For lightly soiled areas. 1 to 2 ounces per gallon of water.
- PreSpray stains - Use sparingly at full strength to heavy duty strength
Tip: Use hot water. The heat makes this chemical work harder to degrease the surface soils.
- Damp-mopping - Dip sponge mop into a bucket of solution, wring out well, and push the sponge across the floor - pressing enough to loosen the surface dirt. Damp mop a small area at a time, wringing the mop out frequently. When damp-mopping a large floor, change the solution several times so that the dirt doesn't get redeposited on the floor.
- Pressure Sprayer - Apply solution using a pressure sprayer set at medium pressure. Let stand for 1 to 2 minutes. Use sponge mop to loosen and pick up soil. Rinse mop frequently in clean water.
- Automatic Scrubbing Machine - Fill solution tank with dilution rates as shown above using hot water. Operate machine as per manufacturer's recommendations. Do not use an automatic scrubber without at least two squeeges installed to remove the excess water used on the raised floor panels. It must be picked up immediately.
- Never wax your high pressure laminate floor.
- Never flood the floor or use more than just a damp mop.
- Never use strong abrasives or scrapers to remove stains.
Note: The manufacturer declines all responsibility for damages resulting from the improper use of this product.
CAUTION- Keep out of reach of children. Harmful if swallowed. Avoid contact with aluminum surfaces or prolonged contact with skin. If sprayed in eyes, flush with water for 15 minutes. If burning persists, contact a physician.